Hobbywing XRotor 20A Micro Brushless Drone ESC

This is the Hobbywing XRotor 20A Micro Brushless Drone ESC.

Features:

• Super Small & Light architecture
• F396 48MHz MCU
• Premium MOSFETs (Toshiba MOSFETs for 20A & 35A ESCs, Fairchild MOSFETs for 30A ESCs)
• Ceramic capacitors
• 3-in-1 drive ICs, 3-ounce copper
• Ultra high efficiency & rapid response – 4 layers of PCBs and other quality components guarantees less heat.
• BLHeli Firmware Ready – Users can flash or upgrade the BLHeli firmware via the signal cable (on ESCs), and program 4 ESCs simultaneously after connecting their flight controller to the BLHeliSuite software if the flight controller uses the CleanFlight firmware
• Damped Light Mode & OneShot125 Mode Supported
• Damped light mode improves the motor retardation and allows users to brake the FPV drones more efficiently. Active-freewheeling technology improves driving efficiency, flight time and heat dissipation.
• Support OneShot125 high speed throttle signal and regular throttle signal (within 500Hz) modes.
• ESC + Motor combo available

Specifications:
Application: FPVs with 130-280mm Diagonal 
LiPo Power input: 2S-4S    
Continuous Current: 20A
Burst Current: 30A
BEC Output: NA
Input wires: 20AWG-100mm* (Red/Black)
Output Wire: Solder tabs (no wires)
Connectors (In/Out): no
Weight / Size: 7g / 24.0×13.9×5.5mm
*Note: All the wire length above is the original length, not the length you see from the outside.

This product was added to our catalog on December 1, 2016